PHILIPS ACT400
Instrukcja Serwisowa

1-3

INSTRUCTION FOR USE
general information
power supply

�rmware upgrade
occasionally, philips releases new software (��rmware�) for your set.

batteries (supplied or optionally available)
inserting batteries
open the battery compartment and insert 2 alkaline batteries of type AA (LR6, UM3). do not use old and new or different types of batteries in combination.

1

connect the mains adapter to DC on the set and to the wall socket (see �mains adapter�).

2

keep mode pressed for 3 seconds. the type of your set and the current version of the �rmware are displayed. Upgrade? is displayed.

3 4

press 9. visit the homepage http://www.nike-philips.com. check if there is a �rmware �le for your set and if the �rmware version is higher than the current version of your set. download the �le and burn it on a cd-rom.

indication of empty batteries
replace the batteries or connect the mains adapter as soon as A blinks and Replace batteries is scrolled. remove batteries if they are empty or if the set will not be used for a long time.

5

insert the cd-rom into the set and keep mode pressed for 3 seconds. Upgrade? is displayed.

Replace batte

6

press 2;. Upgrading is displayed and upgrading starts. this may take some minutes. after upgrading is �nished, Upgrade completeis scrolled. Wrong upgrade file is scrolled: your set already has the latest �rmware or the downloaded �le does not correspond to your set. Upgrade file defect is scrolled: the upgrade �le has been damaged during the download or when burning the cd-rom. download the �le again, burn a new cd-rom and try again. No upgrade file is scrolled: no upgrade �le was found on the inserted cd-rom.

batteries contain chemical substances, so they should be disposed of properly .
average playing time of batteries under normal conditions:

alkaline batteries esp on esp and powersaving on: audio disc mp3-cd
15 hours 24 hours 10 hours

note: if upgrading is interrupted accidentally, repeat step 6 until upgrading is completed successfully.

note: to switch on powersaving, press esp repeatedly during playback until ESP is shown (see �esp and powersaving�).

power supply / head phon es

basic function s

power adapter (supplied or optionally available)
use only the AY 3170 power adapter (4.5 V/300 mA direct current, positive pole to the center pin). any other product may damage the set.

playing a disc
with this set you can play all pre-recorded audio cds all �nalized audio cdrs and cdrws mp3-cds (cd-roms with mp3 �les)

1

make sure the local voltage corresponds to the adapter´s voltage. if your power adapter is equipped with a voltage selector , set this selector to the local power voltage if necessary .

1 2

push the

slider to open the cd lid.

2

connect the power adapter to DC on the set and to the wall outlet.

insert a disc, printed side up, by pressing gently on
the disc´s center so that it �ts onto the hub. close the lid by pressing it down.

note: always disconnect the adapter if you are not using it.

3

press 2; to start playback. Reading CD is displayed. playback starts. the track type (CD or MP3), the current track number and the elapsed playing time are displayed. for an mp3 track, the album number is also displayed and the �lename is scrolled twice.

headphones (HJO20)
connect the supplied headphones to p.

note: p can also be used for connecting this psa to your hi� system. adjust the volume and sound on the psa and your hi� system.

4

press 9 to stop playback. the total number of tracks, the track types (CD, MP3), the number of albums on an mp3-cd and the total playing time (of an audio disc only) are displayed.

use your head when using headphones
hearing safety do not play your headphones at a high volume. hearing experts advise that continuous use at high volume can permanently damage your hearing. traf�c safety do not use headphones while driving a vehicle. it may create a hazard and it is illegal in many countries. even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you.

5

to remove the disc, hold it by its edge and press the hub gently while lifting the disc.

stop [CDA]

15

notes: after pressing 2; it may take some time until the �rst mp3 track is played. 20 seconds after pressing 9 the set switches off automatically.