AIWA A-DV500
Instrukcja Obsługi

MANUAL TUNING

1 Press the TUNER button repeatedly to select the desired band.

When the TUNER button is pressed while the power is off, the power is turned on directly. 2 Press the UP or DOWN button to select a station. Each time the button is pressed, the frequency changes. When a station is received, "TUNE" is displayed for two seconds. During FM stereo reception, is displayed.

To search for a station quickly (Auto Search) Keep the UP or DOWN button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops. To stop the Auto Search manually, press the UP or DOWN button. � The Auto Search may not stop at stations with very weak signals. When an FM stereo broadcasts contains noise Press the MONO TUNER button on the remote control so that "MONO" appears on the display. Noise is reduced, although reception is monaural.

To restore stereo reception, press the button so that "MONO" disappears. To change the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Hold down the TUNER button and press the POWER button immediately. Note that the unit is set to the Direct Tuning mode if the TUNER button is pressed and held down for about two seconds. To rest the interval, repeat this procedure.