SHARP AFA12CE
Instrukcja Obsługi

CLEANING AND MAINTENANCE
WARNING : Turn off the unit before performing any cleaning or maintenance.

CLEANING THE FILTER
If the filter is clogged with dust, the amount of air flow will be reduced, resulting in poor cooling performance. The filter should be cleaned for every 10 days. At the beginning of every cooling season or if the air conditioner has not been used for a long period, clean the filter before starting to operate the unit.

1. REMOVE THE FILTER
Open the grille by gently pulling the arrow marked portion. Then lift and unhook the bottom of the air filter and remove it. CAUTION: Do not open the grille extremely wide, or provide stress to the opened grille. The grille may come off, or the grille shaft may get damaged. If the grille should come off, replace it by following instructions given in page E-3 "CAUTION".

Grille Air filter

2. CLEAN THE FILTER
To remove dust from the filter, use a vacuum cleaner or wash it with water. If the filter is very dirty, wash it with detergent and rinse carefully with water. Dry the filter with a soft cloth. Do not expose the filter to heat or dry it under direct sunlight.

Air filter

3. RE-INSTALL THE FILTER
Fit the top hooks, and then hook the bottom of the air filter. Close the grille firmly. Never operate the unit without installing the filter or the grille open. It may be resulted in serious damage to the unit.

Air filter

CLEANING OF THE FRONT PANEL,GRILLE AND CABINET
To clean the front panel, grille and cabinet, wipe with a soft, dry cloth or with a cloth moistened with a mild soap. Rinse carefully by wiping with a damp cloth and dry completely. Avoid splashing the unit with water. Excessive water will affect electrical insulation and fire may be resulted during operation. Never use erosive chemicals or abrasive cleaners on any part of the unit. To avoid damaging the unit, do not use hot water of over 50°C when cleaning.

OILING OF THE COMPRESSOR AND FAN MOTOR IS UNNECESSARY
The compressor is permanently lubricated and is hermetically sealed. The fan motor is lifetime sealed and does not require oiling.

E-9

ENGLISH