Tekstowy podgląd strony 107 (kliknij aby zobaczyć)
Replacing Photo Conductor Unit (PCU)
E Raise the green handle and slide the photo conductor unit out towards you.
3
Important � Do not tilt or drop the removed photo conductor unit. Moving the unit abruptly can scatter the toner.
� While the photo conductor unit is removed, do not change the toner.
F Take the new photo conductor unit from the box and remove the plastic
bag, holding the handle.
Important � Do not drop or damage the removed photo conductor unit.
� Do not touch the side of the photo conductor unit.
G Put the photo conductor unit removed in step E into the plastic bag emptied
Note � Do not tilt the used PCU after Removing it from the machine. If you do, toner might fall.
in step F, keeping the unit at the same angle as when it was installed. Then, zip the plastic bag.
H Remove the two red sheets from the photo conductor unit in the order
shown in the illustration.
