a coin to remove the two screws on the right side of the printer.
Note � The removed screws are no longer required.
H Use the wrench to fasten the four
socket screws in the order as shown in the illustration (A - D), to secure the holder to the printer.
Important � The order to fasten the screws is, top right, top left, bottom right and bottom left as viewed from the right side of the printer. If the screws were not fastened in that order, the duplex unit might not close completely or the bypass tray might not work correctly.
1
ZAEP511E
F Use the wrench to remove the two
socket screws from the cover on the right side of the printer, and remove the cover.
Note � The removed screws and cover are no longer required.
ZAEP660E
I Remove
the small cover on the right side of the printer.
Note � The removed small cover is no longer required.
ZAEP510E
G Mount the brackets of the holder
by placing them in the printer and pushing downwards slightly.
ZAEP230E