|
Dla tego produktu nie napisano jeszcze recenzji!
SETTING A STACK OF ORIGINALS IN THE DUAL JOB FEEDER (ADF, ARDF)
SETTING A STACK OF ORIGINALS IN THE DUAL JOB FEEDER (ADF, ARDF)
You can insert a stack of originals of the same size into the dual job feeder. These originals are individually fed onto and removed from the exposure glass.
� Some originals are unsuitable for the dual job feeder. See page 23. � You can still use originals that are not recommended for this mode. First make a set of copies of the originals by positioning them directly on the exposure glass, then use these copies as originals. � If you want to set originals of different sizes at the same time, use the User Tools. See page 130.
1 Correct any curl, fold, or crease in the originals 2 Make sure theglass isOriginal originals.is lit and Insert indicator the exposure clear of
before setting the originals.
3 Adjust the guide to the original size. 4 Set the originals face up into the dual job feeder
� � � The last page should be on the bottom. The original guide must touch the front side of the originals. Do not stack originals above the limit mark.
until the Insert Original indicator goes off.
24
|
