TEAC AG-D8000
Instrukcja Obsługi

Tuner
< Make sure the antennas have been connected (see page 3).
1 Select TUNER by pressing the AUDIO button (or the 4 Select the station you want to listen to (auto selection).

TUNER button of the remote control unit).

2 Select AM or FM by pressing the BAND button.

Hold down the TUNING/PRESET button for more than 0.5 seconds. When a station is tuned in, the tuning process will stop automatically. If you want to stop the tuning process, press the TUNING/PRESET button. Selecting stations which cannot be tuned automatically (manual selection) When the TUNING/PRESET button is pressed momentarily (0.5 second or less), the frequency changes by a fixed step. FM: 50 kHz steps AM: 9 kHz steps Press the TUNING/PRESET button repeatedly until the station you want to listen to is found. < �TUNED� is displayed when a broadcast is correctly tuned in.

< If the BAND button is pressed while the source other than TUNER was selected, the source will be switched to TUNER automatically.

3 If �PRESET� indicator is lit, press the TUNING MODE

FM MODE Button

button to select the manual tuning mode.

The �PRESET� indicator disappears from the display. This button is used to change the tuning mode.

Pressing this button alternates between Stereo mode and Mono mode. Stereo: FM stereo broadcasts are received in stereo and the �ST� indicator lights in the display. Mono: To compensate for weak FM stereo reception, select this mode. Reception will now be forced monaural, reducing unwanted noise.

24