Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 18 (kliknij aby zobaczyć)
l
The 9Poven should be cleaned before it gets �excessively . - which means something different to every cook! dirty The self-clean cycle is preprogrammed for 3 hours which
TO SET THE SELF-CLEAN CYCLE TO START LATER:
1. Check to see that oven clock is set correctly (see page 9) and the steps for preparing the oven prior to self-cleaning have been followed. 2. Slide the Door Lock Lever to the right as shown at left. The lever must be all the way to the right for self-cleaning
cleans normal soil in your oven. If your oven is excessively dirty, make sure large spills are wiped up. If the oven is not clean after one cycle, repeat cleaning cycle.
l
l
Make sure oven light is off before setting oven for selfcleaning. Also, never self-clean oven if glass light cover is removed or broken. Keep the kitchen well ventilated during the self-clean
to take place. 3. Push CLEAN button once. 4. Immediately push STOP TIME button once. Then immediately turn TIME/TEMP SET knob clockwise to the time of day when you want the self-clean cycle to be finished
(this time must be at least 3 hours past the current time of day). The oven control will automatically calculate the time of day the self-clean cycle will start.
To avoid the risk of burns, do not touch areas albove the oven door and around the oven vent (cover vent is located in center of backsplash). These areas become hot enough to cause burns during the self-clean cycle. Do not store or set items in front of oven vent since this area can become extremelv warm. TO SET THE SELF-CLEAN CYCLE TO START NOW:
Make sure you have read and followed the instructions
outlined in the previous section �Before Operating SelfClean Cycle.� Check to see that the clock is set at the correct time of day (see page 9). 1. Slide the Door Lock Lever to the right as shown below. The lever must be all the way to the right for self-cleaning to take place. If it is not �DOOR� will appear in display,
For example, if the current time of day is 4:00 p.m. and you want to set the self-clean cycle to be finished at 9:00 p.m., set the stop time for 9:O0. The oven will automatically turn on at 6:00 p.m. and then turn off at 9:00 p.m.
The oven is now set for a delayed start. �DELAY CLEAN� and �STOP TIME� will appear in display The oven will not turn on until the clock reaches the calculated start time. The �ON� will appear in the display when the self-clean cycle starts. NOTE: Since this is a twelve-hour clock, the maximum amount of time you can program for delay is 12 hours.
--
--
/� * * /
2. Push CLEAN button once. �CLEAN TIME� and �3:00� will appear in display Three hours of clean time has been preprogrammed for you.
WHAT HAPPENS DURING SELF-CLEAN CYCLE:
Once the oven has been programmed to start self-cleaning or when the calculated start time for a delayed self-clean cycle has been reached, the oven ON indicator light will turn on indicating that the oven is in operation. As soon as you finish programming, the control lock will light in the display, the LOCK indicator light will come on and the door lock lever will not be able to be moved. This is a safety measure which prevents the oven door from being opened under high temperature conditions.
l
1.4 Q 4-z J-E
L _, --, ---
5-�� -',:E
�. cc4 - L,C
': '3,
C*:8L
pnri . l,,?
d i8JPFA.T.E
The cleaning time in the display will count down. Press the STOP TIME button to see the time of day when clean cycle will be finished, then press CLEAN button to return display to show remaining clean time.
The temperature will continue to rise to about 9OOOF where it will stay for the remainder of the cleaning time. (Note: The first few times the self-cleaning system is used, there may be minor smoking and a slight odor as the oven insulation �cures.� This will disappear after the first few cleaning cycles.) 9 The oven vent exhausts vapor and warm air during selfcleaning cycle. It should always be left unobstructed.
. You may notice some wisps of smoke from around the door or oven vent at the beginning of the cleaning cycle. The vapor and smoke generated during the self-cleaning cycle is catalytically cleaned before being discharged into the room. 18
