PANASONIC AJ-RC905EN
Instrukcja Obsługi

Parts and their functions
Front panel
O P (R) (Q) I
STOP

J

G KF H
START/STOP

K BAR button This is used to switch the images which are output to color bar signals. When lighted:

VTR REW ENABLE MONITOR CHROMA CABLE LENGTH 100m Y/VIDEO CHROMA 50m
ON

FF

PLAY REC CHK

CALL

OFF

VTR WARNING

TALLY
BAR

SET UP

SHUTTER WHITE BAL

AWB

GAIN

ABB

AUTO KNEE

N M

(PUSH)

PR

INTERCOM

MIC
ON OFF

POS2 POS1 SV SS

POS3 B POS4 PRST POS5

A

The color bar signals of the camera recorder are output. When off: The images being shot by the camera recorder are output. L ABB button This is used to adjust the black balance automatically. When lighted: The black balance is now being adjusted. When off: The adjustment of the black balance is completed. Flashing 5 off: The black balance adjustment has failed. M AUTO KNEE button This is used to set the AUTO KNEE function to ON or OFF. When lighted: The AUTO KNEE function is ON. When off: The AUTO KNEE function is OFF. N GAIN button This is used to select the gain value of the video amplifier. 3: The gain value is increased. 4: The gain value is reduced. O SET UP button This displays the menus of the camera recorder. When it is lighted, the menus are displayed on the screen which is connected to the MONITOR connector. P SET UP dial This is used to perform the menu settings. Turn the dial to select a menu, and press it to enter the setting. Menu settings can be performed when the SET UP button O is lighted. If, while the SET UP button is off, the shutter speed selector dial R is set to the SS position, and the SHUTTER button Q is lighted, the SYNCHRO SCAN shutter speed can be set. When the SET UP dial is now turned while keeping it pushed in, the SYNCHRO SCAN shutter speed can be changed continuously. 7

PAINTING
GAIN

POS6

DETAIL R

ENABLE B
BLACK

PB

RCU

CAMERA

L

KNEE POINT PGM

GAMMA GAIN FILTER

AUTO IRIS

IRIS

PUSH
POWER
OFF ON

KNEE SLOPE

M.PED

CHECK

BBS

F CALL button While this button is held down, the tally lamps of the camera recorder are made to light. G TALLY (red) lamp This indicates the red tally signal which is input to the TALLY connector. H TALLY (green) lamp This indicates the green tally signal which is input to the TALLY connector. I WHITE BAL switch This is used to select the white balance memory. PRST: At this setting, the white balance is set to the preset value (3200K). Use it when there is not enough time to adjust the white balance. O The preset value can be set on the camera recorder�s menu to any color temperature. A or B: At this setting, the adjusted white balance value is stored in the memory at the A or B position. J AWB button This is used to adjust the white balance automatically. It does not work when the WHITE BAL switch I is set at the PRST position. When lighted: The white balance is now being adjusted. When off: The adjustment of the white balance is completed. Flashing 5 off: The white balance adjustment has failed.