PANASONIC AJSPD850
Instrukcja Obsługi

Recording and playing
Inserting P2 cards
Note: Before using the unit for the first time, be absolutely sure to set the internal clock using setup menu item No.069 (CLOCK SET).

Removing P2 cards
Do not remove a P2 card while it is being accessed or while it is being recognized after it has been inserted (while its corresponding access LED is flashing orange).

(1) Press the STOP button. (1) Turn the POWER switch of the memory card recorder on (2) Press a card in a P2 card slot until the EJECT button pops out
If the access LED corresponding to the P2 card you want to remove is flashing orange, press the STOP button to make it stop flashing. If the LED does not stop flashing, hold the STOP button down for over a second.

(2) Raise the EJECT button

EJECT button

Insert the card with the label facing up.

(3) Push the EJECT button in to remove the card

(3) Push the EJECT button that has popped out over to the right
P2 card access LED

� When the P2 card is inserted into the memory card recorder, its status is indicated by the corresponding P2 card access LED. For details on these statuses, refer to �P2 card access LEDs and P2 card status.� � When the REC button and PLAY button are pressed together in the stop mode, recording starts on the P2 card corresponding to the access LED which has lighted up orange. Notes: � Even when a second P2 card is inserted into another slot while the data of one card is playing, its access LED will remain off and the other P2 card will not be recognized. The second card will be recognized after the play of the first card has been completed. � The P2 card access LED will flash and the P2 card will be recognized when a P2 card is inserted into another slot during recording. Do not remove the P2 card while it is being recognized.

Notes: � When a P2 card is removed while the thumbnail screen is displayed, the thumbnail screen is automatically exited. � Do not remove a P2 card while it is being accessed or while it is being recognized after it has been inserted (while its corresponding access LED is flashing orange). If a P2 card has been removed while it was being accessed, the �TURN POWER OFF� display will appear on the LCD monitor, and the �AUTO OFF� warning will appear on the display panel. Also, all the P2 card access LEDs will flash rapidly in orange. Turn off the power, and then turn it back on. � The data contained on a P2 card which has been removed while it was being accessed will not be destroyed, but the clips may become irregular. Check the clips first, and then fix them if necessary. (See page 27) � If a P2 card has been removed while it was being formatted, no guarantees are made for its formatting. Turn on the power, and format the card again.

18