3gb66074.fm Page 7 Thursday, March 4, 2004 11:10 AM
CARE AND CLEANING
Important: Do not use water pressure cleaners or steam cleaners. � Clean with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Wipe with a dry cloth. � Do not use corrosive or abrasive detergents, which dull the surface. In the event that one of these products comes into contact with the oven, immediately clean it using a damp cloth. � Slight differences in colour on the front of the appliance are determined by the different materials used, such as glass, plastic and metal.
Exterior of the oven
Accessories
� Soak the accessories in water with washing up detergent immediately after use. .ood residues can be easily removed using a brush or sponge.
Oven cavity
� Do not use abrasive cleaners or pan scourers. Use special oven cleaners and follow the manufacturer's instructions. � After every use, wait for the oven to cool then clean it to prevent the build-up of baked-on food residues. � With long cooking times or when cooking on different levels, especially food with a high water content (pizzas, stuffed vegetables, etc.) condensation may form on the inside of the doors and the seal. When the ovens are cool, dry the inside of the doors with a cloth or sponge. � Clean the glass of the doors with a suitable liquid detergent.
Replacing the bulb
Warning: Disconnect the appliance from the power supply. To remove the side runner frame, push it simultaneously down and towards the centre of the oven (A-fig.1). Then lift the side runner frame upwards to release it from the cavity wall (B-fig.1). Prise off the glass cover C using a screwdriver E. Change the lamp D (fig. 2). Note: use only 25 W/230 V, E-14 type, T300°C bulbs available from After Sales Service. Refit the glass cover, pressing it slightly (fig. 2). To refit the side runner frame, follow the steps above in reverse order. To facilitate cleaning, the oven door can be removed as follows: Hinges . are provided with two movable bolts G. When bolt G is raised, the hinge is released from its housing. Having done this, the door must be lifted upwards and removed, sliding it outwards; hold the sides of the door near the hinges when performing these operations. To refit the door, insert the hinges into their seats and open the door fully. Remember to rotate the two movable bolts G used to hook the two hinges before closing the door (fig. 3). WARNING � Take care not to dislodge the hinge lock system when removing the door as the hinge mechanism has a strong spring system! � Do not immerse the door in water at any time. .ig. 1
