WHIRLPOOL AKT 797/IX
Instrukcja Obsługi

GB

AKT 797
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.

PRODUCT DESCRIPTION SHEET
Removable panstand grids Auxiliary burner Semi-rapid burner Rapid burner Semi-rapid burner 4 ring burner Auxiliary burner control knob Semi-rapid burner control knob Rapid burner control knob Semi-rapid burner control knob 4 ring burner control knob

GB

IE

IT

DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)

SYMBOLS
Tap closed Maximum flame Minimum flame

LIGHTING THE BURNERS
� � � � To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting . Press the knob against the control panel to ignite the burner. After the burner has ignited, keep the knob pressed for about 5 seconds to allow the thermocouple to warm up. This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden draught, an interruption in the gas delivery, boiling over of liquids, etc.). The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before trying to light it again. The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough. In this case, repeat the operations described above.

NOTE:

If the distance �A� between the wall cabinets is between 600 mm and 730 mm, the height �B� must be a minimum of 520 mm. If the distance �A� between the wall cabinets is greater than the width of the cooktop, the height �B� must be a minimum of 400 mm. In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct distance.

PRATICAL ADVICE FOR USING THE BURNERS
For better burner performance, please stick to the following rules: Use pots and pans that fit the burners (see table on the right). Only use flat-bottomed pots and pans. Use the correct amount of water for cooking foods and keep the pot covered. In the case of pans with convex bottoms (WOK), use the support grille provided, which should be positioned only on the 4 ring burner. Burner 4 ring Rapid semi-rapid auxiliary Pot � from 24 to 26 cm from 24 to 26 cm from 16 to 22 cm from 8 to 14 cm

INJECTOR TABLE
Type of gas used Type of burner 4 ring � injector 139 128 95 78 95 87 67 50 95 87 67 50 Rated thermal flow rate kW 10.8 10.8 10.8 Rated thermal flow rate kW 3.50 3.00 1.65 1.00 3.50 3.00 1.65 1.00 3.50 3.00 1.65 1.00 Rated consumption 333 l/h 286 l/h 157 l/h 95 l/h 254 g/h 218 g/h 120 g/h 73 g/h 250 g/h 214 g/h 118 g/h 71 g/h Total rated consumption 1028 l/h 785 g/h 771 g/h Reduced heat capacity kW 1.50 0.60 0.35 0.30 1.50 0.60 0.35 0.30 1.50 0.60 0.35 0.30 17

CATEGORY II2H3+
Gas pressure (mbar) min. rat. 20 max. 25

NATURAL GAS
(Methane)

G20

Rapid Semi-rapid Auxiliary 4 ring Rapid Semi-rapid Auxiliary 4 ring Rapid Semi-rapid

LIQUID PETROLEUM GAS
(Butane) G30

20

28-30

35

LIQUID PETROLEUM GAS
(Propane) Type of gas used G20 20 mbar G30 28-30 mbar G31 37 mbar G31

25

37

45

Auxiliary Configuration model 5 burners 5 burners 5 burners

Air necessary (m3) for the combustion of 1 m3 of gas 9.52 30.94 23.80

ELECTRIC SUPPLY: 230 V - 50 Hz

5019 319 62002

To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.