WHIRLPOOL AKZ 493
Instrukcja Serwisowa

SERVICE
Technical data
Failure codes

Whirlpool Europe Customer Service

AKZ 493/IX 8585 493 01000

28.05.2004 / Page 3 Doc. No: 4812 725 18449

Product Type All

Failure Code F01

Failure Type Temperature Probe

Test First check probe connection. If ok, disconnect the probe and measure its resistance (1000� + 3.75 x Temp ambient). If value is in range, change Antares / Capricorn. Check heating elements insulation (disconnect each heating element and check each terminal for continuity to GROUND). If there is no continuity, change Antares / Capricorn. Replace Capricorn or if applicable reprogram Antares EEPROM using SAM. If the problem persists, change Antares. First check connection between Capricorn and Scales. If connection is ok, connect a new Capricorn to the Scales and check if the appliance works correctly. Otherwise change Scales. First unplug the appliance, wait at least 10sec then reconnect. Verify that latch system works correctly (door has to be closed, motor has to run). If this happens, check the connection between Antares and door latch system. If it is ok, check micro switch functionality (door switch open if the door is open and latch switch open if the door is unlocked). If switches are ok, then change Antares. First check connection between Antares and door latch system. If it is ok, check door switch functionality (open circuit if the door is open, closed circuit if the door is closed). If switch is ok, then change Antares. First check connection between Antares / Capricorn & User Interface. If connection is ok, connect a new User Interface to the Antares / Capricorn and check if the appliance works correctly. In this case change the User Interface on the appliance. Otherwise change the Antares / Capricorn. Change G2 Smart. First check connection between Antares & User Interface. If connection is ok, connect a new G2SMART to the Antares and check if the appliance works correctly. In this case change the G2SMART on the appliance. Otherwise change the Antares First check grill connections. If it is ok, disconnect the heating element and check the resistance between the terminals (approx. 22� ± 3�). If the value is in range, change Antares. First check connection between G2 and TEX. If connection is ok, connect a new TEX to the G2SMART and check if the appliance works correctly. Otherwise change G2SMART

All

F02

Temperature Error

All

F03

A.M. EEPROM

Capricorn only

F04

W.I.S.P. Protocol

Pyro

F05

Door Latch

Pyro

F06

Door Closure

All

F07

Communication UI/AM

TAD TAD

F08 F09

UI EEPROM Communication G2SMART/Antares

Pyro

F10

Primary grill

TAD

F11

Communication G2SMART/TEX