PHILIPS AQ4130/61
Instrukcja Obsługi

Power Supply
Using AC power
1 Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains. 3 Connect the power cord to the AC IN ~ inlet and the wall socket.The power cord is now connected and ready for use. To switch the set off completely, withdraw the power cord from the wall socket. Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. � Helpful hints : To avoid unnecessary energy consumption, always adjust the Source selector to TAPE (OFF) after using the set. Also check that the tape deck keys are released. The type plate is located on the bottom of the set.

General Operation / Radio
General operation
Switching on and off and selecting functions
1 2 To switch on, push the Source selector slider to TAPE or RADIO as desired. To switch off, push the Source selector to TAPE (OFF) and check the cassette keys are released. Helpful hints: To change from TAPE to RADIO , or when you are switching off the set: first, make sure you press the STOP�EJECT 9/ key to end playback and all the cassette keys are released.

2

4 �

Adjusting volume
Adjust the volume with the VOLUME control.

Radio reception
1 2 3 4 Adjust the source selector to RADIO. Adjust the band selector to select your desired waveband, MW, SW or FM. Turn TUNING to tune to a station. �In SW, turn TONE for precise tuning. To switch off the radio, adjust the source selector to TAPE (OFF) position.

To improve radio reception:
� For FM and SW, extend and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set.

�

5