SPECIAL PAPERS (manual feed)
The bypass tray is used to copy onto transparency film, labels, tracing paper, and other special purpose papers. Up to 50 sheets of standard copy paper can be set in the bypass tray. q Automatic duplex copying will not work when a non-standard sized paper is used. If a duplex copying mode is selected and a non-standard sized paper is used from the bypass tray, the corresponding one-sided mode will be selected automatically when the START ( ) key is pressed.
CHAPTER2 MAKING COPIES Special papers (manual feed)
1 2 3
Place the original in the document feeder tray or on the document glass. Open the bypass tray.
Set the bypass tray guides to the width of the copy paper.
q
Be sure to extend the tray when feeding A4R, B4 or A3 (8-1/2" x 11"R, 8-1/2" x 14" or 11" x 17") sized paper. When feeding A3 (11" x 17") sized paper, pull out the metallic support.
4
Insert the copy paper all the way into the bypass tray.
q
q
q
q
CLEAR ALL
CA
A4 A3 A4R
START
q
Labels, tracing paper, and other special purpose papers other than SHARP recommended transparency film must be fed individually. Multiple sheets of SHARP recommended transparency film can be loaded in the bypass tray. Up to 50 sheets of standard copy paper measuring from A6 to A3 (5-1/2" x 8-1/2" to 11" x 17") can be loaded into the bypass tray. For automatic two-sided copying of A5 paper, position the side guides against the copy paper�s longest side. A6 size paper must be fed narrow side into the feed slot and must be fed individually. When adding paper, first remove remaining paper, combine it with the paper to be added and then reload as a single stack.
5 6 7
Press the �PAPER SELECT� key on the touch panel and then select the bypass tray. Set the number of copies. Press the START ( ) key.
