SHARP AR-NB2N
Instrukcja Serwisowa

[ 3 ] UNPACKING AND INSTALLATION
1. UNPACKING 3. INSTALLATION PROCEDURE
This installation procedure is provided for AR-M160/AR-M205/AR-5220 series, AR-168S/168D, AR-M150/M155. For Installation to other models, see the operation manual of the main unit or the service manual.

A. FOR AR-168S/168D, AR-M150/M155
Turn off the main switch of the main unit and remove the power plug of the copier from the outlet.

1. Cut the rear cabinet.
1) Remove the SPF from the main unit and gently place it on the document glass as shown in the illustration. 2) Cut out two cut-out portions from the rear cabinet using a cutter or the like. 3) Use a Phillips screwdriver or the like to open a hole. 4) Remove the screw and then remove the rear cabinet cover. 5) Cut out a part of the rear cabinet cover with nippers or the like as shown in illustration. (Be careful about the orientation of the nippers so that the cross section is flat.)

2. PACKAGED GOODS

2. Attach the network expansion kit.
1) Engage the two pawls on the rear of the network expansion kit with the cutout portions of the main unit and secure the kit with the supplied screw (3 x 14). 2) Connect the connector of the network expansion kit to the connector of the main unit. 3) Secure the rear cabinet cover to the main unit with the screw. 4) Attach the SPF to the main unit.

AR-NB2N

UNPACKING AND INSTALLATION

3�1