WHIRLPOOL ART 642/G
Instrukcja Obsługi

English
energy consumption low, we suggest you periodically scrape off the ice from the walls. Never use poined or sharp objects. We recommend you defrost the appliance once or twice a year, when the layer of frost reaches a 3mm thickness (Fig. 8). To defrost the appliance, operate as follows: - Disconnect it from the mains supply (Fig. 9); - Remove all foods from the compartment. - Turn the thermostat control knob to position q; - Dry the defrost water with a sponge or with a cloth (Fig. 10). At completion of defrosting, dry the compartment walls, connect the appliance to the mains, turn the thermostat control knob as indicated in chapter "Adjustment of the temperature". For this model as well, the defrosting of the refrigerator compartment is automatic. Attention: A temperature rise of frozen foods during defrosting may shorten their storage life.

GB
3) The appliance is excessively noisy. Check that: - the appliance is level; 4) The appliance does not work at all. Check that: - the thermostat control knob is not set to position q; - there is not a power failure; - the supply plug is making good contact with the supply socket; - check the plug fuse by connecting another appliance to the supply socket. For Great Britain only: Check the plug fuse (if fitted). A 13 A fuse must be fitted. Try new fuse - check removable plugs for loose connections and tighten if necessary. Loose connections can cause overheating of the plug: where this has occurred, replace the plug. - The supply cable is broken (See also Note). 5) The interior light does not work See point 4. Unplug the appliance and remove the lamp cover, with a screwdriver (Fig. 13) and check that the bulb is not loose tighten if necessary. To change the faulty bulb, proceed as above and fit a replacement bulb of not more than 15 W rating (Fig. 14). 6) Water on the floor of the refrigerator compartment Check that: - the thermostat is correclty set; - the defrost water drainage system is not blocked; - the drain hole is not obstructed (see chapter "Maintenance") (Fig. 11). Note: When replacing a damaged supply cord, be sure the new cord is correctly clamped. If you have followed the above checks and your appliance still does not work properly, get in touch with the Service division. Addresses and telephone numbers can be found on the Service Registration Card or Booklet. State clearly what is wrong and the type and serial number of your appliance, which are indicated on the rating plate (Fig. 6).

MAINTENANCE AND CLEANING
A periodic and proper maintenance will ensure a longer life to your appliance. When carrying out any cleaning operation or intervention, always disconnect the appliance from the mains supply. Periodically clean the inside of the compartments with a solution of lukewarm water and vinegar. Rinse and dry. Never use abrasives or detergents. Periodically clean the drain situated at the rear (Fig. 11) with the tool provided. Clean the door gasket with water and dry carefully. Avoid soiling the door gasket with oil or grease, which could damage it. Clean the outside of the appliance with a sponge dampened in lukewarm water. Dry with a soft cloth. Clean periodically the condenser (Fig. 12) with a vacuum-cleaner.

HINTS FOR HOLIDAYS
If you plan to be away for a long time: disconnect the appliance from the mains supply, empty and clean the inside. Leave the door open to prevent the appliance from smelling musty. If you plan to be away for a short time: let the appliance operate normally.,To disconnect the appliance temporarily turn the thermostat control knob to position q.

DOOR REVERSIBILITY
1) Remove the lower hinge 2) Remove the door 3) Remove the screw 4) Change the pin 5) Change the foot

HINTS FOR ENERGY SAVING
You can save enery when operating the appliance: - Check the door gasket; level the appliance to ensure a correct door closing. - If the appliance is provided with a compartment, periodically clean it from excessive frost; defrost when the layer on the walls reaches a 3mm thickness. - Periodically clean the condenser. - Open the door only when necessary. Close it as soon as you have removed food. - Do not overload the refrigerator: let air circulate freely inside it. - Do not adjust the thermostat control knob to an excessive cold position: you will waste energy. - Ensure that the appliance is not installed near a heat source such as cookers, radiators, boilers or in direct sunlight.

A

6) Remove the handle 7) Change the bush 8) Mount the handle 9) Fit the plugs

B 10) Change the handle 11) Fit the plugs
12) Mount the door 13) Mount the lower hinge

REVERSIBILITY OF THE LOW TEMPERATURE COMPARTMENT (Fig. A)
1) Open the door and remove the bottom hinge. 2) Take off the door. 3) Take off the catch and fit it on the right. Take off the spring and fit it on the left. 4) Remove the top bushing and put it into its seat on the left. 5) Fit the door on (turned through 180°). 6) Fit the bottom hinge back on. 7) Plug the unused hole with the clip (from the bag).

SERVICE (Fig. 15)
The incorrect operation of the appliance is not always due to a fault but it may also result from poor installation or usage. To prevent unnecessary service calls for which you will be charged, we suggest you consult this trouble-shooting guide. 1) The temperature in the compartments is not cold enough. Check that: - the door is properly shut; - the thermostat is in the correct position (see chapter "Adjustment of the temperature"); - the appliance is not too close to a heat source; - the condenser is clean (Fig. 12); - the low temperature compartment is not covered with an excessive layer of frost. - the air flow is not restricted. 2) The interior temperature is too cold. Check that: - the thermostat control knob is in the correct position;
30

REVERSIBILITY OF THE LOW TEMPERATURE COMPARTMENT (Fig. B)
1) Remove the left door block (2 screws). 2) Remove the hinges at the right hand side (4 screws and remove the door). 3) Remount the hinges at the left and side, remounting the door. 4) Remount the door block at the right hand side. 5) Plug the holes which remain unused with the 2 clips (from the accessory bag).