Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 62 (kliknij aby zobaczyć)
Section
13
Audio Adjustments
1 Touch A.MENU and AUDIO and then touch LOUDNESS. 2
# To turn loudness off, touch
Touch
to turn loudness on.
.
3 Touch or to select a desired level. Each time you touch or selects level in the following order: LOW (low)MID (mid)HIGH (high)
5 Touch and then touch or to select cut-off frequency. Each time you touch or selects cut-off frequencies in the following order: 50Hz80Hz125Hz Only frequencies lower than those in the selected range are outputted from the subwoofer.
Using nonfading output Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. ! When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Touch A.MENU and AUDIO and then touch SUB WOOFER.
# When the subwoofer controller setting is FULL, you cannot select SUB WOOFER.
When the nonfading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is outputted through the RCA output. 1 Touch A.MENU and AUDIO and then touch NON FADING.
# When the subwoofer controller setting is only FULL, you can select NON FADING. (Refer to page 83.)
2
Touch
to turn non fading output on.
.
2
# To turn subwoofer output off, touch
Touch
to turn subwoofer output on.
.
# To turn non fading output off, touch
3 Touch and then touch or to select the phase of subwoofer output. Touch to select normal phase and NORMAL appears in the display. Touch to select reverse phase and REVERSE appears in the display. 4 Touch and then touch or to adjust the output level of the subwoofer. Each time you touch or increases or decreases the level of the subwoofer. +6 6 is displayed as the level is increased or decreased.
3 Touch or to adjust the output level of the non fading. Each time you touch or increases or decreases the level of the non fading. +6 6 is displayed as the level is increased or decreased.
Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are outputted from the front or rear speakers.
