When the ignition switch is turned OFF while the LCD panel is opened, the LCD panel will close after six seconds. When the ignition switch is turned ON again (or turned to ACC), the LCD panel will be opened automatically. Removing or attaching the front panel will automatically close or open the LCD panel. (Refer to page 22.) ! When the ignition switch is turned OFF after the LCD panel has been closed, turning the ignition switch ON again (or turning it to ACC) will not open the LCD panel. In this case, press OPEN/CLOSE to open the LCD panel. ! When closing the LCD panel, check to make sure that it has closed completely. If the LCD panel has stopped halfway, leaving it like this could result in damage. % Press OPEN/CLOSE to open the LCD panel.
# The adjusted the LCD panel angle will be memorized and automatically returned to the next time the LCD panel is opened.
Turning the LCD panel horizontal
When the LCD panel is upright and it hinders the operation of the air conditioner, the position of the panel can be turned horizontal temporarily. % Press FLIP DOWN/CLOCK to turn the LCD panel horizontal.
# To close the LCD panel, press OPEN/CLOSE again.
Adjusting the LCD panel angle
Important ! If you can hear the LCD panel knocking against your vehicles console or dashboard, press ANGLE () to move the LCD panel a little forward. ! When adjusting the LCD panel angle, be sure to press ANGLE (+/). Forcibly adjusting the LCD panel by hand may damage it.
# To return to original position, press FLIP DOWN/CLOCK again. # The LCD panel returns to the original position automatically with beep sounds 10 seconds after operation.
Changing the wide screen mode
You can select a desired mode for enlarging a 4:3 picture to a 16:9 one. % Press WIDE to select the desired setting. Press WIDE repeatedly to switch between the following settings: FULL (full)JUST (just)CINEMA (cinema) ZOOM (zoom)NORMAL (normal)
FULL (full) A 4:3 picture is enlarged in the horizontal direction only, enabling you to enjoy a 4:3 TV picture (normal picture) without any omissions.
% Press ANGLE (+/) to adjust the LCD panel to an easily viewable angle. The LCD panel angle continues changing as long as you press ANGLE (+/) and hold.
