Mounting
7 Install the board securely using the screws (B) and 3 screws (C). (At this stage, install the cable clamp as well.)
Screws (B)
Cable clamp
Screws (C)
8 Tighten the 6 screws (A) for the upper panel cover securely.
Screws (A)
9 After attaching the required cables, insert the power connector and turn the power on. For details on the setting and operating procedures, refer to the operating instructions of the AV-HS300G. If the HD analog board has been connected properly, �ANLG� will appear at the OPT item on the AV-HS300G �s SETUP/STATS menu (5/5).
STATS ALM OPT VER 15/15 NO ANLG 1.00
In order for the analog HD component signals to take effect, select �ANLG� (analog HD component) in the MODE item setting for each of the input channels (IN to IN5) from the AV-HS300G �s SETUP/IN-5 menu (/5). Analog HD component signals and SDI signals cannot be used at the same time in the same input channel. Additionally, the gain of the input signals is set using the GAIN item.(The gain can be set within the �30-step range, and the setting will result in changes of � dB. The amount by which the gain changes per step is not the same for each step.)
IN1-5 SIG MODE GAIN 1/15 IN1 ANLG -30�30
IN2 IN3 IN4 IN5
Removal procedure
Remove the HD analog board by following the procedures for mounting it in reverse.
