|
Dla tego produktu nie napisano jeszcze recenzji!
INSTALLATION
Remove the transit bolts
1.Slacken the three or four bolts (according to model) with the spanner supplied. 2.Unscrew the bolts by hand. 3.Hold the screws together with the plastic spacers and remove them. 4.Close the holes with the plastic covers (supplied with the documents). 5.Keep the transit bolts for future use. If the plastic spacers remain inside the machine: Open the rear panel by removing the twelve screws, remove the spacers and replace the panel. Fit the transit bolts before transporting the appliance as follows: 1.Pry off the plastic covers with a screwdriver and remove them. 2.Insert the transit bolts, performing the steps for removal in reverse order.
Adjust the feet
If the floor is uneven, adjust the levelling feet as required (do not insert pieces of wood, cardboard etc. under the feet): 1.Loosen the locknut using the wrench provided. 2.Adjust the height of the foot, turning it by hand. 3.Tighten the locknut anticlockwise towards the washing machine. If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a 60 x 60 (40) cm sheet of plywood at least 3 cm in thickness. Secure the plywood sheet to the floor. 111
|
