PANASONIC AWPB506AL
Instrukcja Obsługi

Introduction
Installing the SDI card in a convertible camera (such as the AW-E50, AW-E650, AW-E655, AW-E750 and AW-E860) and mounting the camera on the interface bracket makes it possible for a viewfinder and/or inter-communications headset to be used and thus enable the camera to be used as a studio camera. In addition, there are two signal outputs for SDI signals compliant with EBU Tech.67-E standard. Notes � The AW-PB506A cannot be installed to the following models; AW-E00, AW-E00A, AW-E00S, AW-E600, AW-E800, AW-E800A, AW-RP605, AW-PB605 � When the SDI card unit is to be discarded at the end of its service life, ask a specialized contractor to dispose of it properly in order to protect the environment.

Characteristics
� Two signal outputs for SDI signals compliant with the EBU Tech.67-E standard (BBC No. PSF1/M, BELDEN 881 or equivalent coaxial cable; max. 00 m) EDH (Error Detection and Handling) flags complying with the SMPTE RP165 standard can be added. (A switch can be used to enable or disable the addition of these flags.) � An inter-communications headset can be used and its volume adjusted. � The STANDBY/ON switch function of the viewfinder (WV-VF65B, AW-VF80) is incorporated. � Output signals (brightness and composite video signals) to the viewfinder can be switched using the menu settings. � Zebra pattern and safety zone displays appearing in the viewfinder can be switched using the menu settings. � The VIDEO ON/OFF switch function of the viewfinder (AW-VF64) is incorporated. (In order to prevent CRT burn-in, the AW-VF64 does not come with a standby function.)

Precautions for use
� When connecting or disconnecting a cable from any unit, ensure that the power to that unit is turned off. � Do not drop this product or subject it to strong shock or vibration, as this may cause it to malfunction. � Avoid using the unit in very humid or dusty locations, as this may cause it to malfunction. � Avoid using the product at a cold place below �10°C or at a hot place above +45°C because extremely low or high temperature will adversely affect the parts inside. - 4 (E) -

ENGLISH