How to proceed if ...
Clean the filter at the end of every cycle.
� � � � Open the door. Pull the filter upwards. Open the filter. Brush lint using a soft brush or your fingertips.
...you want to correctly care for and clean your Empty the water container dryer: at the end of each drying
cycle. Clean the heat exchanger at least every month. (For further information see chapter �Heat Exchanger� in the Instructions for Use).
� Close the filter. � Push the filter back into place. � Pull the handle to remove the water container. � Empty the water container. � Replace the water container when empty by pushing it completely back in place. � Remove fibres in and around the water evacuation hole at least once per month.
Drying takes too long / laundry is not dry enough.
� Has the correct drying programme been selected? � Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)? � Is the lint filter dirty (filter indicator light on)? � Is the heat exchanger dirty? (for more information, refer to the instructions for use) � Is the room temperature too high? � Are the � � and � � indicator lamps lighting up? The drying cycle is complete and the laundry can be taken out. � If the drying result does not meet your expectation, select a more dry programme. � Is the plug properly inserted into the mains electricity socket? � Is there a power failure? � Has the fuse blown? � Is the door properly closed? � Has a drying programme been selected? � Has the �Start (Pause)� button been pressed? � Has the start delay option been selected? � Is the lint filter clean? � Is the water container empty? � Has the water container been inserted correctly? � Is the heat exchanger clean? � Has the heat exchanger been inserted correctly? � Has any fluff on the heat exchanger seal been wiped away? � Has any fluff on the door seal been wiped away? � Has the water container been inserted correctly?
...you want to check the dryer yourself first:
(If your machine is not functioning correctly, please check the following points before phoning for the customer service � also refer to relevant chapter in the instructions for use) The dryer will not operate (after a power failure, always press the �Start (Pause)� button).
Lint filter, water container or heat exchanger indicator lamps on.
Water droplets underneath the dryer.
AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual). Please have the following details ready when calling your After-Sales service representative: � The nature of the fault. � The dryer type and model. � The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open.
