WHIRLPOOL AWZ 9999
Skrócona Instrukcja Obsługi

How to proceed if ...
Clean the filter at the end of every cycle.
� � � � Open the door. Pull the filter upwards. Open the filter. Brush lint using a soft brush or your fingertips.

...you want to correctly care for and clean your dryer:

Empty the water container at the end of each drying cycle. Clean the heat exchanger at least every month. (For further information see chapter �Heat Exchanger� in the Instructions for Use).

� Close the filter. � Push the filter back into place. � Pull the handle to remove the water container. � Empty the water container. � Replace the water container when empty by pushing it completely back in place. � Remove fibres in and around the water evacuation hole at least once per month.

Drying takes too long / laundry is not dry enough

...you want to check the dryer yourself first:
(If your machine is not functioning correctly, please check the following points before phoning for the customer service � also refer to relevant chapter in the instructions for use)

The dryer will not operate (after a power failure, always press the Start(Pause) button).

Lint filter or water container indicator lamp on.

Water droplets underneath the dryer.

� Has the correct drying programme been selected? � Was the inserted laundry too wet (washing machine spin speed less than 800rpm? � Is the lint filter dirty (filter indicator light on)? � Is the heat exchanger dirty? (for more information, refer to the instructions for use) � Is the room temperature too high? � Are the and indicator lamps lighting up? The drying cycle is complete and the laundry can be taken out. � Is the plug properly inserted into the mains electricity socket? � Is there a power failure? � Has the fuse blown? � Is the door properly closed? � Has a drying programme been selected? � Has the Start(Pause) button been pressed? � Is the lint filter clean? � Is the water container empty? � Has the water container been inserted correctly? � Is the heat exchanger clean? � Has the heat exchanger been inserted correctly? � Has any fluff on the heat exchanger seal been wiped away? � Has any fluff on the door seal been wiped away? � Has the water container been inserted correctly?

AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual). Please have the following details ready when calling your after-sales service representative: � the nature of the fault. � the dryer type and model � the service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open.

3