PIONEER AXM-P7050/ES
Instrukcja Obsługi

Section

Digital Signal Processor

07

Using balance adjustment
You can select a fader/balance setting that provides an ideal listening environment in all occupied seats. 1 Press p to select Fad. Press p until Fad appears in the display.

SLA +4  SLA 4 is displayed as the source volume is increased or decreased.
Notes ! Video CD and CD are set to the same source level adjustment volume automatically. ! Analog4, Analog5 and Analog6 are set to the same source level adjustment volume automatically.

# If the balance setting has been previously adjusted, Bal will be displayed.

2 Press r or q to adjust front/rear speaker balance. Each press of r or q moves the front/rear speaker balance towards the front or the rear. Fad :F25  Fad :R25 is displayed as the front/ rear speaker balance moves from front to rear.
# Fad : 0 is the proper setting when only two speakers are used.

Using the dynamic range control
The dynamic range refers to the difference between the largest and softest sounds. The dynamic range control compresses this difference so that you can clearly hear sounds even at low volume levels. ! The dynamic range control is effective only on Dolby Digital sounds. 1 Press p to select DRC. Press p until DRC appears in the display.
# When playing other than the DVD disc, you cannot switch this mode.

3 Press m or n to adjust left/right speaker balance. When you press m or n, Bal : 0 is displayed. Each press of m or n moves the left/right speaker balance towards the left or the right. Bal :L25  Bal :R25 is displayed as the left/ right speaker balance moves from left to right.

Adjusting source levels
SLA (source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. 1 Press p to select SLA. Press p until SLA appears in the display. 2 Press r or q to adjust the source volume. Each press of r or q increases or decreases the source volume.

2 Press r to turn the dynamic range control on. DRC ON appears in the display. Dynamic range control is now on.
# To turn dynamic range control off, press q.

English
En

21