Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 37 (kliknij aby zobaczyć)
Fault Spin speed cannot be selected.
Possible cause Spinning is already in progress; during spinning the speed cannot be changed. Program selector is set to Drain; spinning is not possible with this program.
Action Select speed before spinning. If required, select another program. Child lock can be selected in pause mode. Clean and dry the detergent dispenser; see Page 30. Use the dispensing aid for liquid detergents. Turn on water tap. Program continues. Eliminate the cause. Clean the filter; see Page 32. Eliminate the cause.
Child lock cannot be The program has already started. selected. Detergent residue in Detergent was damp or lumpy. the detergent dispenser. Water does not enter Water tap not turned on. the machine or detergent is not washed away. y Supply hose kinked or trapped. Water tap closed?" indicated in the display field. Water cannot be seen in drum. Washing solution is not completely drained. Pump blocked?" indicated in the display field. Strainers in supply hose clogged. Water pressure too low. This is not a fault. The water lies below the visible part of the drum. Loose debris is blocking the pump. The water drainage pipe and/or drain hose is blocked.
Clean the pump (refer to Page 31). Clean the water drainage pipe and/or drain hose.
Water is flowing out The thread of the supply hose is not tight. from underneath the machine. Leak in the drain hose. Foam coming out of the detergent dispenser. Repeated spinning. Too much detergent.
Tighten the thread. Replace the drain hose. Mix 1 tablespoon of fabric softener with ½ litre/1 pt of water and pour into chamber II of the detergent dispenser. Reduce the amount of detergent next time.
This is not a fault. Always load large and small items together into the The imbalance compensation system is attempting to drum drum. balance the load through repeated spins. Always load large and small items together into the drum.
The laundry was not Large items of clothing became entangled and could spun. not be distributed evenly in the drum. For reasons of safety the high speed spin cycle was automatically suppressed.
