Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
Gain Setting for Analog Audio Input
INPUT
SETUP
You can adjust the relative volume between the LINE IN terminals. Once the relative volume is set, each component connected to the AZ-1 will have the approximate same volume level.
4 Press and hold the SETUP button for more than 2
seconds (or leave the unit idle for 10 seconds) to exit the Gain setup mode.
1 Select an input to be changed (LINE1, LINE2 or
< Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost. < If you lightly press the SETUP button, the unit enters name and skip setting mode. See page ?? for details.
LINE3/PHONO) by turning the INPUT knob. Start with the component that has the lowest volume level.
2 Press and hold the SETUP button for more than 2
seconds.
The unit enters setup mode, and �GainL*>***� appears on the display. (*** changes depending on your setting.) If you leave the unit idle for 10 seconds, the setup mode will be cancelled.
