� Adjust the POWER slider to the desired sound source: CD, TUNER or TAPE. � The set is switched off when the POWER slider is in the TAPE/OFF position and the keys on the tape deck are released. � The volume, sound settings and tuner presets will be retained in the set's memory.
UND
CO NTROL CENTER
CD R
VOL U
M
CD SY WR E NCRO ST BLE ITARA TR
CD
RADI
STOP PLAY�PA USE
O CA SSETTE
A
Z1 5RE5 6
CORD
ER
ADJUSTING VOLUME AND SOUND
1. Turn the VOLUME/ SOUND CONTROL CENTER control clockwise to increase or anti-clockwise to decrease volume on the set (or press VOLUME 3 or 4 on the remote control). � Display shows the volume level indication VOL and a number from 0-32. 2. To adjust the bass, mid and high frequency levels, press DIGITAL EQUALIZER once or more until the desired option is displayed.
While the option is shown, turn the VOLUME/ SOUND CONTROL CENTER control to increase or decrease (- 5 to + 5 maximum) the desired frequency. � VOLUME can also be adjusted in this way with a level range from 0-32.
UND
CO NTR
OL CENTER
VOL
UM
CD
CD SY RE
E
CD
RADIO
CA
AZ 1 SSET 565 TE RE
CORDER
STOP PLAY�PA USE
PRO
BA LO T
SO
F
UN
D CON
SO SO
� If on, the DIGITAL DBB light goes on. 4. Press INCREDIBLE SURROUND to switch the surround sound effect on or off. � If on, the INCREDIBLE SURROUND light goes on.
E
3. Press DIGITAL DBB to switch dynamic bass boost on or off.
+ � � � 0 � � � � �
VOL
Note: The effect of INCREDIBLE SURROUND may vary with different types of music.
GENERAL INFORMATION
General maintenance
� Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. � To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
Safety information
� Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating. � The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. 6
