PHILIPS AZ2000/10
Instrukcja Obsługi

POWER SUPPLY
AC MAINS
1. Check if the mains voltage as shown on the type plate on the base of the set, corresponds to your local mains voltage. If it does not, consult your dealer or service organisation. 2. If your set is equipped with a voltage selector, adjust it so that it matches with the local mains. 3. Connect the mains lead to the MAINS socket and the wall socket. � The mains supply is now connected and ready for use. 4. To switch off completely, withdraw the mains lead from the wall socket. � Disconnect the mains lead from the wall socket to protect your set during heavy thunderstorms. � To avoid overheating of the set a safety circuit has been built in. Therefore your set may disconnect under extreme conditions. If this happens, switch the set off and let it cool down before reusing it.

RADIO
English
DYN AMIC BAS ULTR A BAS S BOO ST S

Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

RADIO RECEPTION
1. To select the desired station waveband, set the source selector to (MW/FM). 2. Tune to a radio station using the tuning knob. � For FM, pull out the telescopic aerial. Incline and turn the aerial. Reduce its length if the signal is too strong (very close to a transmitter). � For MW, (AM) the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by
VO LU M E

INC RED SUR ROU ND E IBL

turning the whole set. 3. Adjust the sound using the VOLUME, INCREDIBLE SURROUND and BASS controls. 4. To switch off the radio, adjust the source selector to the TAPE/OFF position (with the cassette keys released)

PA U

SE
S TO P

5