Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
BA-115SP Bassamp Cube with Digital Effects
THE TOP PANEL:
1. 0dB INPUT: Connect your �passive� bass guitar here using a shielded instrument cable. This input is not padded and is best suited for basses without active electronics. 2. -15dB INPUT: Connect your �active� bass here using a shielded instrument cable. This input is padded 15dB and is best suited for basses with active electronics and/or �hot� pickups. 3. VOLUME: Use this control in conjunction with your instrument�s volume controls to adjust the level of the signal sent to the preamp. For the best signal to noise ratio and maximum headroom, start with this control at 5 or greater. 4. STYLE: This five-position switch is used to control the tone of the amplifier. Experiment with the Style and other eq controls (#5,6,7) for the results which suit you best. The settings of the style control are as follows:
5. LOW: This control is used in conjunction with the style control to adjust the low frequency level of the amplifier. 6. MID: This control is used in conjunction with the style control to adjust the midrange level of the amplifier. 7. HIGH: This control is used in conjunction with the style control to adjust the high frequency level of the amplifier. 8. LEVEL: Use this control to adjust the level of the output signal from the amplifier. This control also adjusts the signal level of the CD Inputs (#12), the Headphones jack (#13) and the Line Out jack (#15). 9. EFFECTS SELECT: Use this control to select the desired digital effect. A listing of the effects is shown on page 6. 10. EFFECTS ADJUST: Use this control to adjust one of the parameters of the selected digital effect. A listing of the parameters for each of the effects is shown on page 6.
