INSTALLATION
Positioning If the dryer is fitted next to kitchen units, make
The appliance may be placed in any room, provided hose is partially squashed, drying efficiency will the house must be able to easily absorb this moisture. Normally, absorption is only possible in houses where If hose is completely squashed, the safety cutthere is very little humidity. Otherwise, the room must outs with which the machine is fitted may operate. have ventilation towards the outside; generally, an open door or window is enough. Condensation discharge through a vent hose The capacity of the venting circuit must be at least Condensation may be discharged either through a 150 m /hour. Check that the air inlet and outlet vents vent outlet provided at the back or through the front or are unobstructed. right side outlet. The best way of evacuating the moisture is through a vent hose to the outside of the building. Use the speRemove the collar by cial 100 mm diametre flexible hose supplied with the pulling it out of the vent appliance connected to one of the air outlet vents with outlet. Attach the collar collar supplied. to the vent hose until The unused outlet vent(s) must be covered. tight. Never connect the air vent hose into an existing discharge pipe or duct, as this could be dangerous, might disturb neighbours and could cause the dryer to malfunction. Advice: If the hose is long and the room temperature low, moisture might condense to water inside the hose. This is an unavoidable natural phenomenon. To prevent this water from Iying in the hose or flowing Fit the collar into the required vent outlet by proceedback into the tumble dryer, it is advisable to drill a small ing as follows: hole (dia. 3 mm) in the lowest point of the hose and to place a small container below it (see �A� in the picture). Condensation discharge at the back
3
sure that the vent hose is not squashed. If the be reduced, resulting in longer drying times and the following precautions are taken. higher energy consumption. The appliance expels hot, very moist air. The rest of
The vent hose collar is placed in the rear vent outlet.
P0466
Push the vent hose with collar firmly into the vent outlet.
A
P0060 P0751
Connect the other end of the hose to an opening in a door window. Fit a suitable shield or point the hose downwards to prevent any rain water and wind from getting in. Rain and ind shields for placing o er openings s
