Private Bank Scanning
Programming Frequencies into Channels
Before the scanner begins Private Bank scanning, you must program a frequency into at least one channel. Program frequencies you purchased from your dealer, from various free and FCC-based sources on the internet, or from the Frequency guide included in BCT8 package. You will need to program each frequency into the scanner�s channels in order to hear these frequencies. 1. While Private Bank scanning is activated, press HOLD/RESUME and enter the channel number where you want to store a frequency by using the keypad, then press HOLD/RESUME. � Change the channel by using the � or � key. 2. Enter the frequency you want to store by using the keypad and . (decimal key).
3. Press E to store the frequency into the channel. 4. If you want to program another frequencies into the channel, select another channel by using the � or � key. Note: � To clear a mistake while entering the frequency, press repeatedly until the display is cleared.
.
(decimal key)
� If you enter a invalid frequency, an error tone will sound and appears on the display. To clear the Error message immediately, press . (decimal key). � Even if you don't enter full numbers as a frequency number, the scanner will automatically select the nearest valid frequency.
Deleting a Stored Frequency
To delete a stored frequency: a. Select a channel. b. Press 0. c. Then press E. Note: Channels with no frequencies are automatically locked out.
