|
Dla tego produktu nie napisano jeszcze recenzji!
6-2 Advanced Automatic Editing
6-2-2 Performing Quick Editing
After selecting the edit mode, quick editing can save you time by allowing you to set edit points and preview the results at the same time. Do quick editing as follows:
For even quicker editing
1
Press the PLAYER or RECORDER button to select the VTR to be operated, locate the position for the IN point on the tape in the respective player and recorder VTR, then stop the tape at that position. Press the AUTO EDIT button to start editing. While viewing the monitor, press the OUT button while holding down the ENTRY button at the point where you want to stop editing. The point at which editing started becomes the IN point, and point where editing stopped becomes the OUT point.
2,4 1
2 3
3
1
5
Performing quick editing
Press the PLAYER or RECORDER button to select the VTR to be operated, locate the position for the IN point on the tape in the respective player and recorder VTR, then stop the tape at that position. Press the PREVIEW button to perform previewing. The points selected in Step 1 are set as IN points and the IN point is displayed on both VTRs. When the tape reaches the position that you want for an OUT point, press the OUT button while holding down the ENTRY button. The OUT point is set, and both player and recorder VTRs stop two seconds later. Perform previewing again to check the position of the edit points and, if necessary, modify the edit points. Press the AUTO EDIT button. Quick editing starts. When quick editing ends, the recorder VTR stops at its respective OUT point, and the player VTR stops two seconds after its respective OUT point.
Chapter 6 Editing
2 3
4 5
6-16
Chapter 6
Editing
|
