jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
2-4. Input Level Range Confirmation and Level Setting
2-4. Input Level Range Confirmation and Level Setting
Measurement Equipment Audio signal generator Audio distortion meter, BKPF-202 Preparation 1. Connect each equipment. (Refer to Fig.1 in Section 2-1-2.) 2. Turn on the power of the main unit (PFV-D20/D50/D100A/D200A/D300) and warm up for ten minutes. Procedures 1. Provide an analog audio signal of 1 kHz, +4 dBm from an audio signal generator to the ANALOG IN AUDIO 1 connector of BKPF-205. Provide the "L" output signal from BKPF-202 to an audio distortion meter, and read the level.
BKPF-205 ANALOG IN AUDIO Input to "1" Input to "2" Input to "3" Input to "4" BKPF-202 DIGITAL IN AUDIO Provide an output signal from AES/EBU OUT 1 of BKPF-106A Provide an output signal from AES/EBU OUT 1 of BKPF-106A Provide an output signal from AES/EBU OUT 2 of BKPF-106A Provide an output signal from AES/EBU OUT 2 of BKPF-106A BKPF-202 ANALOG OUT AUDIO "L" becomes effective. "R" becomes effective. "L" becomes effective. "R" becomes effective.
2. Turn 1RV102 (A-4) counterclockwise until the clutch is activated and clicks. Confirm that the level is less than 0 dBm. 3. Turn 1RV102 clockwise until the clutch is activated and clicks. Confirm that the level is more than +18 dBm. 4. Turn RV102 so that the audio output level is +4 ± 0.1 dBm. 5. The ANALOG IN AUDIO 2 through 4 connectors are also the same in procedures as described above. Confirm and adjust the volumes below according to steps 1 through 4. . ANALOG IN AUDIO 2 connector : 1RV202 (A-5) . ANALOG IN AUDIO 3 connector : 1RV302 (A-6) . ANALOG IN AUDIO 4 connector : 1RV402 (A-6)