|
Dla tego produktu nie napisano jeszcze recenzji!
MANUAL TUNING
When an FM stereo broadcast
Press the TUNER MODE MONO appears MODE/OSC button on the remote although
contains
noise
unit or the
button
on the main
control. reception is monaural.
on the display.
Noise is reduced, MODE
BAND +,To restore TUNERMODE/ stereo reception, repeat the above again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. allocation system If you use this unit in an area where the frequency is 9 kHzLstep, change the tuning interval. Press the POWER button while pressing button. To reset the interval, repeat this procedure.
1 Press the TUNEFUBAND button on the main unit or the BAND button on the remote control repeatedly to select the desired band. m
When the TUNER/BAND button is pressed while the power is tuned station is off, the power is turned on and the previously received (Direct Play Function).
the TUNER/BAND
m
button to select a station.
the frequency changes. STEREO is displayed.
When the AM tuning
interval
is changed, are cleared.
all preset stations The preset
(see
�PRESETTING STATIONS) have to be set again.
stations
2 Press the 44
During FM stereo
or W
reception,
Each time the button is pressed,
To search for a station quickly (Auto Search)
Keep the ++ or button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops. To stop the Auto Search manually, press the 4+ or button. The Auto Search may not stop at stations with very weak signals.
q
For better reception FM
Extend the rod antenna is inside and orient the unit. it for the best reception. Position the unit for the best AM The antenna reception.
kl!lu~ .. --_=-.
l!!-
6
ENGLISH
|
