WHIRLPOOL CCG556W
Instrukcja Obsługi

Surface

Burner

Bases

The surface burner bases are not removable. Clean with warm soapy water and a sponge or dishcloth. Burned on grease can be removed with a household cleaner, such as Fantastik or 409, and a sponge. To prevent scratching, do not use abrasive cleaners or scrubbing pads. NOTE: Be careful not to spill liquids through the holes in the burner bases.

Porcelain

Spillover

Bowls

Never wipe a warm or hot porcelain enamel surface with a damp cloth. For general daily cleaning and light soil, wash with warm soapy water, rinse, and dry. To remove grease spatters, spray with cleaners such as Fantastik or 409. DO NOT use abrasive or caustic cleaning agents which may permanently damage the finish.

Igniters
If the igniters get dirty or greasy, clean with a toothbrush and warm soapy water. Rinse and dry thoroughly. DO NOT STRIKE or PRY the ceramic igniter.

Glass Cooktop
The tempered glass cooktop will withstand temperature changes while cooking. Although impact resistant, treat this glass cooktop with the same care you would any glass material. Clean glass cooktop after surface has cooled. Wipe with a clean, damp sponge or cloth. Rinse and dry thoroughly to prevent a filmy residue. A glass cleaner may be used to remove smudge marks and stains.

Control

Knobs

The knobs on the control panel can be removed with the controls in the OFF position. Pull each knob straight from the shaft. Wash knobs in warm soapy water or dishwasher; do not use abrasive cleansers or materials. To replace each knob, match flat partof knob opening with the flat on the shaft, returning in OFF position. IMPORTANT: Never use a metal blade to pry knob off. If knob cannot be easily removed, tuck the folds of a cloth dishtowel under the knob ski rtand pull the towel upward with steady, even pressure. tMPORTANT" Be careful to replace the knobs with gentle pressure. Never hit the knob on the shaft with your hand or any other object. NOTE: When knobs are removed for cleaning, be careful not to spill liquids through holes in the control area. 11