RECORDING
q When recording important selections, be sure to make a preliminary test to ensure that the desired material is being properly recorded. q The VOLUME, X-BASS and EQUALIZER controls may be adjusted with no effect on the recorded signal (Variable Sound Monitor). q Metal and CrO2 tapes should not be used for recording or dubbing.
s Recording from the built-in CD player
(CD Synchronized Recording System)
REC PAUSE POWER
ON/ STAND-BY
1 2 3 4 5
Press the ON/STAND-BY button to turn the power on.
Press the CD button and load the desired disc. q Use the APMS function to store the tracks you want to record in memory. (See page 10.) Load a cassette into the TAPE 2 cassette compartment.
CD TAPE (1 2) TUNER (BAND)
Press the REC PAUSE (q 6) button. q "SYNC" and "REC" will flash. Press the 0 /R (TAPE 2 0) button. q "SYNC" will disappear and "REC" will light up. q CD playback will start approximately 5 seconds after the tape starts.
To stop recording:
TAPE 1 TAPE 2
Press the s (CD s) button. The CD and tape will stop. Note: q When the end of the tape is reached while recording, the CD player will display the track number which was being played at that time, and stop automatically. If you want to restart recording from the beginning of the interrupted track, turn over the tape, press the REC PAUSE (q 6) button and then the 0/R (TAPE 2 0) button. (If tracks have been stored in memory using the APMS function, recording will restart from the first track stored in memory.)
CD TAPE TAPE 2 CD ON/ STAND-BY TAPE(1 2) TUNER (BAND)
s Dubbing from tape to tape
1 2
Press the ON/STAND-BY button to turn the power on.
s Recording from the built-in radio
Load a prerecorded cassette into the TAPE 1 cassette compartment. Insert a blank tape into the TAPE 2 cassette compartment. q It is recommended that the recording tape be the same length as the master tape.
1 2 3 4
Tune in to the desired station. (See pages 11-12.) Load a cassette into the TAPE 2 cassette compartment. Press the REC PAUSE (q Press the
0/R 6)
3 4 5
Press the TAPE (1 display. Press the
0/R
V
2) button until "TAPE 1" appears in the
6) 0)
Press the REC PAUSE (q (TAPE 2
button. button.
button. button.
To stop dubbing:
Press the s (TAPE s) button. q TAPE 1 and TAPE 2 will simultaneously stop.
q "REC" will flash. (TAPE 2
0)
q "REC" will appear. Note: q If a whistling noise is heard while recording from an AM station, move the AM loop antenna to a position where noise is no longer heard from the unit.
s Erasing recorded tapes
q Make sure that TAPE 1 is not in use.
1 2 3 4
Load the tape to be erased into the TAPE 2 cassette compartment. Press the TAPE (1 V 2) button until "TAPE 2" appears in the display. Press the REC PAUSE(q 6) button. Press the
0 / R(TAPE
