SHARP CDBA3100H
Instrukcja Serwisowa

CD-BA3100H
80 TOP PLATE F

37° Mark position

42 LIFT GEAR A 45

32 33

46 30

10

47

11

41

35 43 44 40

STB HOLDER HEIGHT ADJUSTING METHOD

Adjusting procedure 1. Turn the mode big gear approx. 37 degrees in the arrow direction. 2. Viewing from the front side of the mechanism, verify that the guide ribs (CHANGE BOX L/R and STB HOLDER)of tray are as tall as each other. 3. If they are not, bend the lever for adjustment. (Refer to the details.) Note: Also apply the same adjustment on the R side.

02(102) CHANGE BOX L RIB 03(147) STB HOLDER RIB 03(147) STB HOLDER RIB

When low (Broaden the gap.) Bend this portion to adjust the STB HOLDER

When high (Narrow the gap.) (121) OS LEVER

04(103) CHANGE BOX R RIB

Adjustment procedure 1. Rotate the MODE BIG GEAR by 37° in the arrowed direction. 2. Check that the guide ribs (CHANGE BOX L/R and STB HOLDER) on the arrowed TRAY are at the same height when looked from the front. 3. If they are not, bend the OS LEVER to adjust them. (Refer to the detail drawing.) Note: Adjust the R portion in the same procedure.

Figure 23 � 23 �