INSTALLATION
Power supply Inserting batteries in the remote control English
1 Plug the power cord supplied into the MAINS connector on the CD recorder, then into a mains socket. 2 Press POWER ON/OFF. �The recorder is now in Standby mode (Red led on). It takes approximately 2 seconds for the led to light up after pressing POWER ON/OFF. Note: - If the CD recorder is in Standby mode (red led on), press any key to activate the recorder. - The CD recorder will automatically adjust to the local mains voltage. - When the CD recorder is in the �OFF� position, it is still consuming some power. If you wish to disconnect your player completely from the mains, withdraw the plug from the AC outlet. 1 Open the battery compartment cover. 2 Insert 2 batteries (�AA�, LR-6 or UM-3; as supplied) as shown. 3 Replace the cover. Note: We recommend you use 2 batteries of the same type and condition. Batteries contain chemical substances, so they should be disposed of properly.
Setup recommendations
- Place the CD recorder on a solid, vibration free surface. - Do not place the CD recorder near a source of heat or in direct sunlight. - Do not use the CD recorder under extremely damp conditions. - If the CD recorder is placed in a cabinet, make sure that a 2.5 cm space remains free on all sides of the CD recorder/player for proper ventilation.
Important:
- Do not put the CD recorder on top of other equipment that heats up the CD recorder (e.g. receiver or amplifier).
