WHIRLPOOL CDU20J
Instrukcja Obsługi

CARE

AND

CLEANING

each cycle with a drain for touch control models, press the Drain/Off pad. (See page 1.) ° Disconnect door. the electrical supply and prop open the

Clean the control panel with a lightly dampened cloth. Dry thoroughly. Do not use abrasives or sharp objects on the panel, They can damage it. To care for a wood top on a convertible dishwasher, first wipethe top with a damp cloth to remove surface dust, then dry. Next, saturate a cloth with mineral oil and apply a heavy coat to the wood top. Let it stand overnight. The next day apply a thin coat of mineral oil and rub with a soft dry cloth. Repeat these steps every few months to maintain the appearance of the

CHANGING PAN E LS

COLOR

If you are redecorating, dishwasher's new colors.

you can change your

front panels to match or blend with your

wood top. The inside normally takes care of itself. Occasionally check the tub bottom for any large pieces which may have collected. Periodically clean the bottom edge of the door liner if any spills or food soils are noticed after a cycle. To remove any odor, try one of the following: 1. Put baking soda in both cups. Select the Normal cycle and let the water circulate for about 10 minutes. Stop the dishwasher by unlatching the door. Let it sit overnight. Then restart the dishwasher by latching the door and letting it complete the cycle. 2. Select the Normal cycle and let the dishwasher fill with water. Then open the door and pour ]/acup of chlorine bleach into the bottom of the dishwasher, Latch the door and let it complete the cycle.

Two panels are held in place by the door trim and the trim on the panel below the door. Each side of each panel is a different color. Or you can paint a panel with the color of your own choice. How to change the door panel inserts: 1. Take out the three trim screws on either side of the dishwasher door. Remove the side trim. 2. Slide out both of the insert panels at once. 3. Put the panel with the color you want in front. (Handle the panels carefully. Edges may be sharp.) 4. Replace the side trim and screws. How to change the lower panel inserts: 1. Remove the four panel attachment above panel, two below.) 2. Remove the entire panel. the top trim. screws. (Two

3. Try using a lemon scent detergent and/or rinse aid to help periodically freshen a dishwasher interior. It is also recommended that you switch detergents if you notice a strong chemical or chlorine odor

3. Take out the three screws and remove 4. Slide out both of the insert panels

at once.

5. Replace the panels with the color you want in front. 6. Replace the top trim and screws. 7. Replace the entire panel and four attachment screws. Color insert panels for the door and panel can be

from your present detergent. 4. Run the dishwasher more frequently. Use the Rinse & Hold cycle (if available) to remove any food soil that may cause an odor. STORING YOUR

replaced by 1/4" thick wood inserts to match your kitchen cabinets. Get them from your nearest cabinet dealer. Dimensions for 1/4" wood inserts: Door Panel: 181£'' H x 231/2 W. '' Lower Panel: 411A_"H x 231/2 W. ''

DISHWASHER
If your dishwasher will be in storage or an unheated area exposed to freezing temperatures, please follow these recommendations: ° Clean the dishwasher inside and out as explained in the Care and Cleaning section. (Also clean the door gasket), � Operate the drain portion twice to ensure most of the water will be removed. Most dishwashers begin

Note: Do not operate the dishwasher while changing the panels or when the lower access panel is removed. When installing wood panels, you may need to check with your dealer for advice and/or assistance.