WHIRLPOOL CDU510CB
Instrukcja Obsługi

Automatic Dishwasher Detergent
Water Temperature
Hot water is needed to activate automatic dishwasher detergent. Entering water temperature must be at least 120°F. Enhance wash performance by increasing water temperature to 130°F. or 140°F . However, water temperature should not exceed 140°F. Check water temperature with a candy or meat thermometer. Turn on hot water faucet nearest dishwasher. Put thermometer in a glass and let water run continuously into glass until temperature stops rising. If water temperature is below 120°F., adjust water heater. If water is less than 120°F. and water heater cannot be adjusted, select a longer cycle or water temperature boost (some models) and fill both dispensers at least half full with automatic dishwasher detergent. If outside temperatures are unusually low, or if water travels a long distance from water heater to dishwasher, increase water heater temperature. If hot water has not been used for several hours, water in pipes may be cold. Turn on hot water faucet and allow water to run until hot then start dishwasher. If a lot of hot water was used recently, allow water heater time to recover before operating dishwasher.

Automatic Dishwasher Detergent

WARNING
To avoid property damage, use only automatic dishwasher detergents or wetting agents recommended for use in a dishwasher. 1. Check phosphate content. Phosphates help remove food deposits and prevent hard water from forming spots or film on dishes. Automatic dishwasher detergents with a higher phosphate level usually clean better. If phosphate content is low (8.7% or less), use more detergent. Keep automatic dishwasher detergent fresh and dry. Do not store powder detergent under sink because there is too much moisture. Do not put powder detergent into dispenser until ready to wash. If powder detergent gets old or lumpy, throw detergent away.

2.

WARNING
To avoid personal injury, keep automatic dishwasher detergents and wetting agents out of reach of children.

8