SHARP CDXP160W
Instrukcja Obsługi

CD-XP160W

System connections (continued)
T
Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear panel before plugging the unit into a wall socket. If necessary, adjust the selector to correspond to the AC power voltage used in your area. Turn the selector with a screwdriver until the appropriate voltage number appears in the window (110 V, 127 V, 220 V or 230 V - 240 V AC).

ENGLISH

Preparation for Use
System connections -

E-9

T
z z

Connecting the AC power lead

After checking all the connections have been made correctly, connect the AC power lead to the AC power input socket, then plug the AC power lead of this unit into the wall socket. If you plug in the unit first, the unit will enter the demonstration mode (see page 10). Notes: Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time. Never use a power lead other than the one supplied. Otherwise, a malfunction or an accident may occur. AC Plug Adaptor In areas (or countries) where a wall socket as shown in illustration is used, connect the unit using the AC plug adaptor supplied with the unit, as illustrated. The AC plug adaptor is not included in areas where the wall socket and AC power plug can be directly connected (see illustration ).

02/5/27

CD-XP160W(X)E1.fm