To control a TOSHIBA VCR, first press the VCR button. The buttons shown below will then control the VCR. The rest of the buttons operate the TV as usual. If you have another brand of VCR, you can probably program your Remote to control it. Details are on page 11. To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter. See page 11. The shaded buttons can be used to control the cable TV converter. Press the CABLE button whenever you control the cable TV converter.
Aim at the VCR or cable TV converter
VCR
POWER
Press to control VCR.
MTS
TIMER
POWER
CABLE
TV
VCR
CABLE
Press the button to turn the VCR (or converter) on. Press again to turn off.
CHANNEL s / t
Press to control cable TV converter.
Channel Number
1 4
2 5 8 0
C.C A P T
3
CH
6 9
CH RTN
Press s button to select next higher channel.
VOL
Press the numbers desired for direct access.
7
100
ENT
RESET
EX
Press t button to select next lower channel.
ENTER
IT
XDS
ADV
SUR
FAV
-
MENU
FAV
+
Some VCR's and Cable TV converters requires ENT to change channel number. This button does not function until you program the Remote Control to enter the VCR (or CABLE) code.
PLAY
ADV
MUTE RECALL TV/VIDEO SURROUND
Reference Section Advanced Basic Operation Preparation Set up
STOP
Press to begin tape playback.
FF
Press to stop the tape.
REC
STOP SOURCE
PLAY PIP
REC
TV/VCR REW
FF
Press to rapidly advance the tape. In playback mode, press to view the picture moving rapidly in forward direction.
REW
Press to start recording.
TV/VCR
STILL LOCATE SWAP
Press to the TV mode to view one program while recording another program.
Press to rewind the tape. In playback mode, press to view picture moving rapidly in reverse.
