PANASONIC CF18
Instrukcja Serwisowa

! Line Processing of the Wireless Module,Port PCB and Modem
Insert it into the boss as it comes over the Cable.

Cable Holder Sheet
Details of cable arrangement

Tape

Safety Working

1

Safety Working
Pass the Cable under the card.

DU PCB ASSY Pass it under the Coin Battery Cable and fix it.

Tape up to the far side.

Details of cable arrangement

Cable
Insert the end of the Sheet into the space between the Main Board and the bottom of the LAN Connector. 0~0.5mm

Pass the Black Cable over the Gray Cable and connect them. Draw them sideways in parallel as shown above.

..
0~0.5mm

Side surface

PCMCIA Sheet

Safety Working
Modem Cable

Pass it at the right of the Coil.

Wind the coil securely to avoid coming off.

Sub material: PET TAPE 1 (19 mm width x 4 cm)

0~1mm

DU Sponge A

0~0.5mm

0~1mm

Pass the Cables through the notch of the Board. *Do not bend sharply. Avoid rubbing against the Board and damaging of the Cable.

Screw
0~0.5mm Attach the insulation sheet for the Modem Cable. Remove the Modem PCB before using the Tape and the Screw.

DU Sponge C
0~0.5mm

Tape

Mini PCI Card Sheet
Screw

5�2mm

Ensure it is set in the Hooks on the both sides of the receiving Connector. (Not necessary for model without W-LAN Module)

Sub material: PET TAPE 1 (19 mm width x 4 cm)

Fold back and attach.

Gasket
1~2mm

1~2mm

7-26