MINOLTA CF910
Instrukcja Serwisowa

3. Press the Start key to feed paper through the copier to determine if an adequate length of loop is formed before the Fusing Rollers.

1154D215AA

1154D212AA

1154D213AA

Retarded

Correct

Advanced

The loop length is too long causing the paper to have too much slack.

A good length of loop is No loop is formed causing the formed as the paper moves paper to be taut. into the Fusing Rollers. 4. If the timing is advanced or retarded, change the setting of Fuser Speed. Adjustments Retarded: Increase the setting. Advanced: Decrease the setting. 5. Check the length of loop again and repeat the above steps until a good length of loop is obtained. 6. Using the same procedure, adjust for �Heavy Stock 2 and OHP Film�. 7. After the adjustments have been made, touch �Ex.�.

1154D266CA

D-118