SONY CFD-ZW150
Instrukcja Obsługi

Waking up to music (continued)

Tips � The display window dims while the waking up timer is on. � You can have the player go on the next day at the same time. Just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them. Note During the timer mode, you cannot change the tape player to the tape function. To operate the tape player, press STANDBY until the t indication disappears from the display first, then operate the tape player.

6

Press STANDBY. The t indication appears in the display and the power goes off. At the preset time, the power will go on and music will play for 2 hours.

To check/change when the playback will start Press TIMER for about 2 seconds, then DISPLAY/ ENTER. Each time you press DISPLAY/ENTER, a stored setting lights up. Change the setting if you need to when the setting lights up. When you finish checking the setting of volume, press TIMER again. To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in in step 1 on page 17, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player. To stop play Press POWER.

18

The Timer

CFD-ZW150/.ZW160/ZW200.E_3-859-373-1X.U2/CA2/AU6