JVC CHX1500RF
Instrukcja Serwisowa

CH-X1500RF

2.5.5 Mounting the front slider and rear slider (See fig.45, 46) (1) Position the unit with the rear side facing down, then rotate the third gear in the direction of the arrow (clockwise) until the lift arm comes to the position at which the holes are exposed. (2) Mount the front slider from the top. Rotate the third gear counterclockwise until the hole of the slider is lined up with the right hole of the stud. (3) Attach the E-washer on the shaft. (4) Position the unit with the front side facing down, then mount the rear slider. Check that the r, s and t positions are correctly mounted as shown in Fig. 46. (5) Rotate the third gear in the direction of the arrow (counterclockwise) until the lifter unit is at the top position.

E-washer Front slider

Stud

Psition so that the stud and right hole are lined up.

Rotate until the holes are lined up.

Set the holes are exposed. Lift arm Fig.45

r

s

t

Lifter unit

Fig.46

Rotate the third gear to move the slider.

1-18 (No.49804)