JVC CHX470RF
Instrukcja Serwisowa

CH-X470RF Mounting the front slider and rear slider (See Fig.45 and 46)
1. Position the unit with the rear side facing down, then rotate the third gear in the direction of the arrow (clockwise) until the lift arm comes to the position at which the holes are exposed, as shown in Fig. 45-1. 2. Mount the front slider from the top. Rotate the third gear counterclockwise until the hole of the slider is lined up with the right hole of the stud, as shown in Fig. 45-2. 3. Mount the E-washer on the shaft. 4. Position the unit with the front side facing down, then mount the rear slider. Check that the u, v and w positions are correctly mounted as shown in Fig. 46. 5. Rotate the third gear in the direction of the arrow (counterclockwise) until the lifter unit is at the top position.
Rotate the third gear to move the slider Stud

Front slider

E-Washer

Position so that the stud and right hole are lined up

Check after mounting

Fig. 45-2

Fig. 45

Fig. 45-1

Set so the holes are exposed Rotate until the holes are lined up

u

v

w

Rotate the third gear to move the slider

Fig. 46

1-16