HITACHI CL2554TAN
Instrukcja Serwisowa

Service manual CL2554AN / CL2854AN
5-2 IF The TDA936x has an alignment free IF PLL demodulator. The fully integrated oscillator is automatically calibrated, using the 12 MHz crystal as a frequency reference. The IF frequency is simply set in TV-Processor by I2C bus. The AFC information is available via I2C bus from the TV-Processor status bytes. The controlling software uses this information for tuner frequency tracking ( automatic following ). The AFC windows is typically 125Khz wide. The minimum frequency step of the tuner is 62.5 kHz. This AFC function is disabled when a program is tuned using the direct frequency entry or after fine tuning adjustment. Therefore it is recommended to tune channel with the TV search function ( manual or ATSS ) or using the direct channel entry to enable the Automatic Frequency Control. SAW filters Ref. K3953M Standard B/G - D/K - I - L/L� Features - IF filter for video application - TV IF filter with Nyquist slopes at 33.9 MHz and 38.9 MHz - Constant group delay - IF filter for audio application - TV IF audio filter with two channels - Channel 1 (L�) with one pass band for sound carrier at 40.40 MHz - Channel 2 ( L, D/K, I, B/G) with one pass band for sound carriers between 32.40 MHz and 33.40 MHz

K9650M

B/G - D/K - I - L/L�

For SECAM L and L� the TDA936x is switched to positive modulation via I2C bus. SECAM L� only occur in VHF band I and have their picture and sound carrier interchanged, compared to SECAM L and PAL B/G channels. For SECAM L� the picture carrier is situated at 33.9 MHz and the AM sound carrier at 40.40 MHz. The IF PLL reference is tuned from 38.9 to 33.9 MHz, this is done via I2C Bus and the SIF filter is switched from channel 2 to channel 1 ; this is done by pin 4 of TDA 936x. The tuner AGC time constant is slower than for negative modulation, because the TDA936x reduces its AGC current. To even slower the AGC time constant an extra series resistor R103 is added. To prevent IF overload when jumping from a very strong transmitter to a weak transmitter a diode D101 has been added The SAW filter ( SF1 ) has a double Nyquist slope at 38.9 MHz and 33.9 MHz needed for this multistandard application. The disadvantage of this choice is that a 5.5 MHz trap filter ( Z501 ) is needed to suppress the residual sound carrier in the video for B/G signals.

- 37 -