HITACHI CM630ET
Instrukcja Obsługi

s FOR THE CUSTOMERS
�

IN THE U.K.

THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINIAND EUROPE. FOR THE U.K. PLEASE REFER TO THE NOTES ON THIS PAGE.

iMPORTANT
WORDING FOR CLASS I

FOR UNITEDKINGDOM
INSTRUCTION BOOKS AND LABELS

EQUIPMENT

The mains lead on this equipment value of which is indicated on the an ASTA or BSI approved BS 1362 detachable never use the plug with ensure it is of the same colour as available from your dealer.

is supplied with a moulded plug incorporating a fuse, the pin face of the plug. Should the fuse need to be replaced, fuse must be used of the same rating. If the fuse cover is the cover omitted. If a replacement fuse cover is required, that visible on the pin face of the plug. Fuse covers are

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. Should it be necessary to change the mains plugs, this must be carried out by a competent person, preferably a qualified electrician. If there is no alternative to cutting off the mains plug, ensure that you dispose of it immediately, having first removed the fuse, to avoid a possible shock hazard by inadvertent connection to the mains supply.

WARNING:

THIS EQUIPMENT

MUST

BE EARTHED

iMPORTANT The wires in the mains lead are coloured in accordance with the following code: Green and Yellow = Earth, Blue= Neutral, Brown = Live, Green & Yellow to Earth Brown to Live

Fuse Blue to Neutral Cord Clamp As these colours may not correspond with the coloured markings identi~lng the terminals in your plug, proceed as follows: The wire which is coloured GREEN and YELLOW must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol @ or coloured GREEN or GREEN and YELLOW. The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.

4